1.Brick machines should be installed on the concrete ground, the horizontal variation allowed 0.6‰; shaft joint axiality variation is 0.5mm; regulation metal cushion block which used for the horizontal can not over three pcs and should be symmetry on both side of the bolt.
2.Cutter platform,mud roller machine roller and extruder exit should low 1-3mm in turn.
3. The centre line of two belt pulley must be in same level with the belt trough ,each belt set must it the same tightness degree.
4. Check the integrality of the spare parts, rinsing them. Revise the wrongly place, adjust the clearence of the bearing.
5. Check if there is lubricate grease in the bearing,if the lubricate grease metamorphose please change it.
6. It has two procedure of the test run.
1).running without load for 1-2 hours
2).running with load (based on the running without load is normal) DIV division:
First segmentation: load 25% of the rated value
Second segmentation: load 50% of the rated value
Third segmentation: load 75% of the rated value
Forth segmentation: load 100% of the rated value
Each segmentation should be no less than 2 hours and the temperature must be steady. The machine when loading running should not shake, leak oil or other abnormal noise. The gear box temperature can not over 40°C, oil temperature can not over 60°C, bearing temperature can not over 80°C. Revise all the malfunction before put the machine in production.
Contact us: Mob: 0086 13119147931
没有评论:
发表评论