Install,adjust and commissioning of brick machine

1.Brick machines should be installed on the concrete ground, the horizontal variation allowed 0.6‰; shaft joint axiality variation is 0.5mm; regulation metal cushion block which used for the horizontal can not over three pcs and should be symmetry on both side of the bolt.

2.Cutter platform,mud roller machine roller and extruder exit should low 1-3mm in turn.

3. The centre line of two belt pulley must be in same level with the belt trough ,each belt set must it the same tightness degree.

4. Check the integrality of the spare parts, rinsing them. Revise the wrongly place, adjust the clearence of the bearing.

5. Check if there is lubricate grease in the bearing,if the lubricate grease metamorphose please change it.

6. It has two procedure of the test run.

1).running without load for 1-2 hours

2).running with load (based on the running without load is normal) DIV division:

First segmentation: load 25% of the rated value

Second segmentation: load 50% of the rated value

Third segmentation: load 75% of the rated value

Forth segmentation: load 100% of the rated value

Each segmentation should be no less than 2 hours and the temperature must be steady. The machine when loading running should not shake, leak oil or other abnormal noise. The gear box temperature can not over 40°C, oil temperature can not over 60°C, bearing temperature can not over 80°C. Revise all the malfunction before put the machine in production.

Contact us: Mob: 0086 13119147931

E-mail:brickmachine1984@gmail.com

Skype:brickmachine1984

Brief intruduction of fully automatic clay brick machine:

a) Oil hydraulic machine according to the standard of intenational.

b) The vibration system contains platform vibration and mould vibration, so the products is very close-grained and produced quickly.

c) Machine frame: Maganese steel with China national standard.

Control system

a) PLC intelligent control. Man-machine interface, control system equipped with complete logic control, production program, malfunction diagnosis system and remote control function.

b) The computer is of fault diagnosis system. Warning signal is propitious to eliminate the fault. Combine with long-distance controlling system, it can achieve scrutiny, controlling, diagnosis.

 Available raw materials for automatic clay brick machine

crushed stone, sand, cement, dust and coal fly ash, cinder, slag, gangue, gravel, perlite and other industrial wastes.

Fully Automatic Brick Making Machine Advantages

Fully Automatic Brick Making Machine, Large Capacity and Energy Saving 

1. Wide use of raw material. The industrial wastes, such as coal ash, gangue, slag, smelting slag and the end of raw materials can be made into blocks. More environmentally friendly, energy saving, waste recycling and reuse.
2. The body using high-precision, high-strength castings and special welding techniques and materials, rigid, and resistant to vibration, long life.
3. A multi-purpose machine, through the replacement of mold can produce different specifications of brick, hollow block, curb stone etc.
4. The whole process with PLC intelligent control system and the human-machine interface dialogue, easy to ensure the effectiveness of the best machines.